Is the engine of your car or motorbike often difficult to start? Or is the fuel consumption more wasteful than usual and the sound becomes rough? Be careful, yes, all those symptoms are signs that your car or motorcycle injector device has a problem. The injector is an important device that serves to spray fuel into the combustion chamber of the engine. When problematic, this component may not be able to send pulses to the Electronic Control Unit (ECU) sensor according to its proper dose. In fact, one of the functions of the ECU is to regulate the pressure and frequency of fuel bursts into the combustion chamber of the engine based on the pulses received by the sensor. The jet of fuel and air in the combustion chamber must be precise, so that the result is maximum. If it is not correct, it means that the injector has a problem. When the fuel injector has a problem, the bursts become weak. The non-strong jet of fuel from the injector to the combustion chamber it occurs because the injector needle is clogged with dirt. Small particles that clog the needle on the injector can come from fuel whose shelter at public fuel pumping stations (gas stations) is not clean. In fact, dirt can come from the fuel tank in a car that is subject to corrosion due to the chemical compound process when the tank is empty for a long time. The particle size is indeed small, about 10-30 microns so the fuel filter is sometimes unable to filter it. Although it is very small, its presence is quite disruptive to the performance of the injector, especially if the dirt continues to increase over time. To solve this problem, there is a solution from AutoGard in the form of Autogard Heavy Duty Carb Clean & Injector Spray. Autogard Heavy Duty Carb Clean & Injector Spray is a cleaning fluid specially formulated to effectively clean the carbon scale and also dirt on the carburetor, injector and combustion chamber without damaging or causing corrosion to the components. Autogard Heavy Duty Carb Clean & Injector Spray is one of the capable liquids to knock out stubborn dirt, carbon deposits, and oil marks that stick to injectors. Autogard Heavy Duty Carb Clean & Injector Spray can also be used to clean carburetors, CVT components both on cars and motorcycles, especially with the packaging in a high-pressure spray can, allowing this carburetor cleaning liquid to be applied 360 degrees with a tight spray that will immediately destroy all dirt. Heavy Duty Carb Clean & Injector Spray from Autogard is really living up to the name because this "magic liquid" can immediately dissolve the dirt deposits that clog the injector and dry out quickly. In addition to drying quickly, the Heavy Duty Carb Clean & Injector Spray from Autogard is also specially formulated to be able to clean carbon scale and dirt on the carburetor, injector, and combustion chamber effectively without damaging or causing corrosion to components. Even more steadily, this cleaning fluid is very capable to be used to clean noncat surfaces such as engine covers, throttle bodies, intake components, and vehicle spark plugs.
